pitone02@yahoo.it
03-29-2013, 11:18 PM
I have a new ufc cable that give always rx2 error during boot.
tested on ufs and atf with few phones and jig.
phones goes in local mode if alive (so vcc, bsi and gnd cable are working) and is possible to check info of the phone but when use chech fbus or trying to flash.....rx2 error.
can i check my cable in any way?
already posted on gsm forum in official gpg support section with no answer from gpg team
tested on ufs and atf with few phones and jig.
phones goes in local mode if alive (so vcc, bsi and gnd cable are working) and is possible to check info of the phone but when use chech fbus or trying to flash.....rx2 error.
can i check my cable in any way?
already posted on gsm forum in official gpg support section with no answer from gpg team