Dragon box Pinfinding Problem Solved Check out !

[.::EXTREME::.]

Solution:



Open your Gpg Dragon box
Connect your box to A-B connector
While your box is connected, connect you multitester rod shown to this image...




after you hear a beep....disconect mutitester....
then disconnect A-B connector...
then wait a few minutes.....
then reconnect box...
then upgrade your box firmware to this: [Only registered and activated users can see links. ]
then your box is back to work again....



Its Tested Solution.

We Need Feedback




CHECK THIS TESTED SOLUTION..

HELLO ALL MATES I SHARE THIS TRICKS 100% working tested me..
many times.. all tricks posted here i try but still not working..
i decide open my box and all yellow mark reworks use soldering iron...next this method....
use multe tester set in X1
connect negative to black, and connect positive in red in 5sec. or until your box responds..sounds,

then short 5 sec. A and B until your box responds.....

remove and connect again your box and now UPDATE IN FIRMWARE 1.58.

Here my prove and working this method ..... many thanks to all and specially GPG TEAM.....

Note: check all IC your box and REWORK









Hope so help other user... good luck..........

if not work pm me i try to help

email add: [Only registered and activated users can see links. ]

THANKS FOR snipper_gsm FOR THIS REPORT.

[mohammed]

thanks & wish you happy new year

[elshad]

Thankss bro Tested 10000 % working solution Eraz Team

[JRbong2k]

wow thanks for this solution sir......

i try this solution on my gpgdragon...

[wdson]

Don't work for me... i try downgrade to 1.58 Fw but show this mensage: Conjuct box error !! i try change usb but unsuccessfully
My box don't find any pinout after i upgrade to 1.59 =/

[.::EXTREME::.]

Don't work for me... i try downgrade to 1.58 Fw but show this mensage: Conjuct box error !! i try change usb but unsuccessfully
My box don't find any pinout after i upgrade to 1.59 =/

Check this [Only registered and activated users can see links. ]

[Vinhotao]

expensive colleague'm having the same problem of my friends GPG was functioning normally, but after updating the FW 1.59, stopped working already tried the solution posted that colleagues here in the forum but did not succeed.
it worked normally with FW 1.56D.
would like some more specific help on this bug. so if some GPS stopped working or a large part of them.

I thank the attention

Vinhotao
Cabecell - GSM Solutions
Manaus - AM - Brazil.

[lucky2010]

dear sir i try this solution but not solve my prob when i connect multitester i can't hear any beep i mean my device can't beep plz help me......

[muddssar gee]

itry this solotion but not warking plese give me this solotion any one video or give me adress in pakistan ihope imeat you iwant imete you plese help me sir

[kudos]

plz provide many more solutions