How to use HTC Cable

[gsm9l]

How to use HTC Cable Addon

IMEI REPAIR
- Power on your HTC in normal mode (USB Debugging enabled),
- Connect HTC Cable (Flex must be connected in htc cable with gold pins up),
- Connect also micro-usb cable to phone
- Go to HTC Cable, Service tab, Repair IMEI - Input your IMEI.

CREATE GOLDCARD
- Connect HTC Cable to computer
- Insert desired MicroSD in special tray from HTC Cable
- Go to HTC Cable, Service tab, Create Goldcard.

CHANGE CID
- Power on your HTC in normal mode (USB Debugging enabled),
- Connect HTC Cable (Flex must be connected in htc cable with gold pins up),
- Connect also micro-usb cable to phone
- Go to HTC Cable, Service tab, Change CID - Input new CID (CID 11111111 = SuperCID)


SECURITY FLAG
- Power on your HTC in normal mode (USB Debugging enabled),
- Connect HTC Cable (Flex must be connected in htc cable with gold pins up),
- Connect also micro-usb cable to phone
- Go to HTC Cable, Service tab, Security Flag (Will do S-OFF)


DIRECT UNLOCK (NOT CLEAN S58 DATA) - Nothing is lost from your phone
- Power on your HTC in normal mode (USB Debugging enabled),
- Connect HTC Cable (Flex must be connected in htc cable with gold pins up),
- Connect also micro-usb cable to phone
- Go to HTC Cable, Locks tab, Direct Unlock


CLEAN S58 DATA (SIMLOCK, S-OFF, SUPER-CID) FACTORY LIKE - Any information from your phone is lost !!!
Autodetect version:
- Power on your HTC in normal mode (USB Debugging enabled),
- Connect also micro-usb cable to phone
- Connect HTC Cable to computer
- Insert MicroSD in special tray of HTC Cable
- Go to HTC Cable, Locks tab, Clean S58 Data
- Mark Make Goldcard and Write Diag
- Select AUTODETECT at DIAG file selection
- When you will be asked by software, remove battery and Micro-USB cable, insert HTC Cable flex in your phone, remove goldcard from htc cable and insert it in your phone, connect Micro-USB cable.
- Power on your HTC in BOOTLOADER mode (Vol Down + Power),
- Follow instructions from Micro-Box AIO window.

Manual version: (When you know BOOT Version)
- Connect HTC Cable to computer
- Insert MicroSD in special tray of HTC Cable
- Go to HTC Cable, Locks tab, Clean S58 Data
- Mark Make Goldcard and Write Diag
- Choose DIAG file for your HBOOT version (You can see version from Bootloader Vol Down + Power)
- When you will be asked by software, nsert HTC Cable flex in your phone, remove goldcard from htc cable and insert it in your phone.
- Power on your HTC in BOOTLOADER mode (Vol Down + Power),
- Follow instructions from Micro-Box AIO window.

WBR,
gsm9l